Recent content by jack

I have one and am selling my guns due to old age (79yrs) It is LNIB with all paperwork and 3 magazines. I have probably shot it 200 times over the years. I am not a dealer so I would have to ship it to one after getting their FFL copy. Mine has the thumb safety which I guess many don't. If you...

Does S&W still make a J frame that is all steel and what model numbers would they be? And where can you get one?

Thanks for the info

I'm getting blowback on the OUTSIDE of the cylinder for about a quarter inch on each cylinder hole on my model 66. I have a Kuhnhausen book but can't find what the barrel cylinder gap should be. Anyone know?

Looking for a good condition 38 spl cylinder for a model 10.

SOLD, thanks

This is a new, never installed stainless hammer for the later model N frame revolvers. Asking 17.00 shipped

These are factory smooth target grips with matching grain. On the left side is the football cutout, on the right side is the complete cutout. These are factory and have not been modified. Is there some reason for this or did the factory somehow screw up ?

As new 1911 4" holster with thumbreak for safe cocked and locked carry. Asking 25.00 shipped

Thanks, I'll try that

Anyone have an extra? Thanks

Looking for wood grips that end at the bottom of the grip frame with or without finger grooves. To fit a S&W model 66 with a round butt. Thanks

It is not cut for a safety on the right side and they are a slight bit thicker than my factory grips.

My wife bought these but my 1911 has the shorter grip. Asking 43.50 shipped. Unknown what the wood is but they are pretty.

If you would be interested in a NIB Colt Pony 380 email me for pics [email protected] asking 900.00 shipped to FFL