Recent content by Jaeger2000

The number on the frame matches the number on the bottom of the grip. There is no visible number on the yoke.

Unfortunately, I am. Thank you for your help anyway. You guys are awesome!

Hello everybody. I am new to this forum and revolvers, but not guns in general. I enjoy hunting and sporting clays for several years now.

> Where is that number? On the back side of the yoke, the spot you indicated in your pictures. I removed the cylinder to get to it.

Found a #: D742xxx

Sounds plausible. It was a steal, so I don't mind it having no value as a collectible. All I do care about is that it is safe to shoot. Thank you very much guys.

> I bet you might be in Germany. Correct. > Show us the serial number on the cylinder, and a look inside the chambers. Refer to picture attached. > Also, is there a number on the bottom of the barrel? No.

> Can you determine if there is a SN stamped on the rear face of the cylinder? Yes and it matches the two numbers on the frame (one at bottom of grip, one behind the yoke). > With the grips removed can you see any evidence of welding? No, refer to attached pictures. Thank you for your...

> A full side view showing both sides of the entire gun would be more helpful. Got it.

> Regarding the serial number, does it have a letter prefix? No prefix. > Five shots or six? Six. Attached you will find three pictures. If you need me to take a picture of a specific part, please let me know.

Hello everybody, I am new to this place and looking for help identifying my first S&W revolver. Type: Hand Ejector S/N: 202xxx Caliber: 38 S&W Spl Barrel length: 2 inches Sights: Fixed Strain Screw: Yes Butt Swivel: No Lanyard Ring: No Screws: 5 Thank you so much for helping me out!