Recent content by jas4u

Because it's a slide lock and not a slide release.

350 OTD 9mm with TS

And because I got bored due to canceled work schedule this is on the works after 30mins of work. While this ones were previously completed few weekends ago.

Same question.

Not selling to TN, GA and AL residents. Too bad.

How about for regular .40 Randy?

If only I have time, I can make one for you for free.

Thanks. This is easy to make.

Wow, same experience. FSS and flat faced trigger failed on mine also, ended up using a production frame on a limited division to complete all stages.

M&P9 FS and M&P40 FS are exact same outside dimensions.

Hi, can you take a picture of the back side? Thanks.

Wow, where is that place?

I just started this and still trying to learn.

Thank you sir. By the way, would you suggest brass, steel or aluminum magwell for m&p?

Hello all, again. I have a question regarding magwell for USPSA limited. Is it possible to install the magwell which is intended for IDPA ESP into a firearm to be used in USPSA limited? I am asking this is that the magwell I am trying to buy from speedshooters and taylorfreelance are out of...