Recent content by Jeff63a

Upon further investigation, I have determined that the TDP hole in the upper receiver is actually slightly forward of the holes in the lower receiver. This causes the pin to pass through the upper, and be just offset enough once it reaches the left side of the lower to require a punch and...

I've run 300 rounds through it now. I wasn't expecting much change, but it's still as tight as the day I picked it up. While I can appreciate the idea of compressing the upper and the lower, with the thought that this will align the holes better, making it easier to push the pin, it just...

I just picked up an M&P-10 this week. While performing the first breakdown and a thorough inspection, I ran into a problem almost immediately. The Takedown Pin should be easily pushed through the two receivers, then, easily pulled the rest of the way from the other side. However, the Takedown...

Same Issue With M&P 10 I just picked up an M&P-10. I am having the same issue. The takedown pin cannot be budged without using a hammer and nylon punch. I have removed the grip to ensure the detent and spring were installed properly. They were. To ensure there was no issue with the TD pin...