Recent content by Jetman22

The gun shop that had it for sale wanted $1650. The grips were not numbered to the gun It did have target hammer,trigger,&sights No box 8 k serial number range. Went back to see if he had any bites on the gun. He sold it. Sent from my iPhone using Tapatalk Pro

What kind of grips are these? Saw them on a Model 18 Thanks Sent from my iPhone using Tapatalk Pro

I would save up till I could buy a K-32 Model 16- 16.3 They are expensive. But once you get past the initial cost. You will love the gun. If you don’t. You will be able to get your cost back out of it. If you go the 32 H&R Mag route 16-4 Just remember it’s a full lug gun and a little heavier...

Ive used reeds in a 357 Max 180 gr SSP bullet Very accurate and good Ammo. Sent from my iPhone using Tapatalk Pro

Winchester 25-20 brass is available on gun broker. Right now. Not mine and don’t know them. A lot easier to buy than make. Sent from my iPhone using Tapatalk Pro

Lowered the price Sent from my iPhone using Tapatalk Pro

This is a set of grips I bought used for my K frame model 53. They don’t fit so I’m moving them on. The pics show my model 53 with the grips. Look at the pics and see what I mean about the fit. I’m not sure they were made for a k frame. Or what model. So it’s up to you to figure out if they...

I think what was referenced to about being discontinued is the Hornady #2210 40gr Jet bullet Sent from my iPhone using Tapatalk Pro

The Ruger Hawkeye is on my wish list!! Sent from my iPhone using Tapatalk Pro

What started it for me was in 1965. I received an H&R single shot in 22 Rem Jet Magnum as a Kid. I didn’t have a Smith until about 10 years ago. I found a Model 53 in a pawn shop. It was a shooter grade. Some blueing wear from a holster. And it had a set of thumb-rest grips. It came with 6...

Yes Sent from my iPhone using Tapatalk Pro

I have a model 53 22 jet mag. I bought a 22 lr cylinder. I need a yoke n crane. Is there another model that would work on the model 53. Such as a model 10. Thanks Sent from my iPhone using Tapatalk Pro

Huthike and 29-1. Me 2 on H&R That’s what made me get a model 53 To go with my Topper Sent from my iPhone using Tapatalk Pro

And also case lube on the casings when you reload. Dry cylinders / Dry shells less than top end loads. And most problems with cylinder lockup will go away. Happing shooting. Sent from my iPhone using Tapatalk Pro

Don’t forget the S&W of all time. The K 32 masterpiece. A 32 S&W Long Very expensive and collectible. Sent from my iPhone using Tapatalk Pro