Recent content by jhkunkel

  1. J

    Cylinder not rotating when the trigger is pulled on occasion

    Occasionally on my Smith & Wesson 642 when doing some dry fire practice the cylinder occasionally does not rotate after I pull the trigger. No dirt or powder buildup, the cylinder spins freely when the gate is open. At times it works just fine but then at times it just stops turnin I haven't...
  2. J

    Model 10 Double Action Trigger pull

    I can't stop tinkering with them. I think it's a disease. By the way the Model 60 operates perfectly now.
  3. J

    Model 10 Double Action Trigger pull

    Here are a couple of pictures of a Smith & Wesson model 10 - 7 The serial number on this particular gun is a 3D 49994 Does anyone know the date of manufacture on this gun?
  4. J

    Model 10 Double Action Trigger pull

    Very useful information I thank you very much.
  5. J

    Model 10 Double Action Trigger pull

    Thanks to everyone for their replies it is appreciated. I intend to leave the model 10 is it is now set up and I'm sure I will be very happy with that.
  6. J

    Model 10 Double Action Trigger pull

    When I first started the thread it was because I was interested in what the standard double action trigger pull and the standard single action trigger pull for a Smith & Wesson model 10 would be. I purchased this model 10 on GunBroker and it appears to have been fired very little. The DA trigger...
  7. J

    Model 10 Double Action Trigger pull

    Wow it appears there is a great variance of opinions on the strain / adjustment screw. I have installed the Wolff reduced power mainspring and a 13-pound rebound spring and that is where I am getting my 10 lb double action and two and a half pound single action pull. I have gone over the entire...
  8. J

    Model 10 Double Action Trigger pull

    Why not? It seems that many use it as such.
  9. J

    Model 10 Double Action Trigger pull

    Why the concern about adjusting the strain screw?
  10. J

    Model 10 Double Action Trigger pull

    Sorry I meant "Trigger"
  11. J

    Model 10 Double Action Trigger pull

    Why is it not considered an adjustment screw/ Does it have a detrimental effect on the triage?
  12. J

    Model 10 Double Action Trigger pull

    What is the average Trigger Pull on a Smith & Wesson Model 10? Mine has a 10 lb trigger pull in DA and 2.6 in SA Is this within spec? If I loosen the strain screw will that help lessen the DA trigger pull without adverse effect? Thanks, Jim
  13. J

    Date of Mfg on a J frame model 60 no dash

    Thanks to everyone for the helpful information.
  14. J

    Date of Mfg on a J frame model 60 no dash

    Very nice. Do you use it as a carry gun? Is it dated around the same time as the one I have asked about? Jim
  15. J

    Date of Mfg on a J frame model 60 no dash

    I should have mentioned that i removed the stock grips and replaced them with a pair of Uncle Mike's that I had laying around. Does the "R" have any significance in the serial number? Thank You for your help. jim
See more
Back
Top