Recent content by K-Jun

Yes, it was thoroughly cleaned. I'll remove the side plate tomorrow and watch it closely. Thanks

Got it all back together today and it locks up when cycling slow. If you cock it fast it will never lock up. The cylinder dosent lock up tight either... Has a little movement. Trying to figure out what parts need replacing, the old girls been rode hard and put up wet. :eek:

Thank you for the welcome.:D I checked the cylinder and it has not been sleeved. I am not reloading so it would be pretty pointless to replaced the cylinder. I disassembled it last week and ran it through my ultrasonic parts cleaner. It removed 90% of the rust but I still have several spots...

Thank you guys for helping me figure out what I have. To bad I can't question him about how he acquired this BSR. I have no idea where his true service revolver went. He never spoke much about his time there. The BSR is rusted and pitted pretty bad. It does not cycle and lock up correctly. I...

Hello! I recently inherited a rough condition Revolver from my grandfather. He was in the navy during WW ll. I am trying to learn any details I can. The right side of the barrel has 38 S&W CTG stamped on side and directly under it has NP 38 1.15 4 tons stamped. Barrel length is 3 5/8". On...