Recent content by marktc223

Everything about this Airman's unfortunate death sounded very fishy from the beginning. This must be a updated version of spin the "death" bottle.

I carry my Sig Sauer M18 military with the Romeo-M17 & Foxtrot1X AIWB. Also carry spare 21rd magazine.

Post #6 is correct for Florida.

Acually the casings on steel cased ammo are softer than brass cased ammo. What sometimes happens is during the round being stripped from the mag into the chamber, the bullet gets pushed back into the casing allowing the round to chamber just i bit more deeper and you get a lighter strike on the...

Received this message from Sig Sauer to my email. This is an unedited message. Note to moderator: This is a large message from Sig Sauer. Sorry about the format. P320 Information...

The factory trigger is as good as or better than anything Apex makes IMHO.

That is the correct thread size and length using a flat head socket cap screw. Use blue loc-tite - torque to 12 inch pounds. Also, the slide is cut for a RMSc optic footprint.

This is what I've done so the finish isn't damaged from any more ejected cartridge hits on the slide. I carefully trimmed and fitted helicopter tape in the area where this was occurring. I've done this on many firearms where there are areas of high abuse to the finish from normal use. Helicopter...

Is anyone getting brass cartridge striking marks above the extractor on the slide surface? Got back from the range yesterday after shooting a couple of hundred rounds and had many brass hits from the ejection of the cartridge on the slide right above the extractor. Was shooting both Speer Gold...

Tried that multiple times before going to the range and made absolutely no difference in freeing/loosening up the following rounds in a fully loaded (22 rounds) magazine. The only thing that worked was what I stated in my earlier thread.

On the Federal American Eagle (AE5728A) ammo, I chambered the same round three times from the magazine by using the slide release to load the round in the chamber. On the third chambering, the bullet came loose and fell out of the cartridge. So, it's basically not a good idea to chamber the same...

Well, I went to the range yesterday and shot six full magazines. The first two separate magazines did have a FTF after the first of 22 rounds was shot. Had to drop the mag, clear the FTF round, tap the mag to bring the rest of the rounds to the top of the mag, reload and continue to shoot. The...

Just got my 5.7 and both the magazines will only accept 16 cartridges of the Federal American Eagle 5.7x28MM FMJ 40GR with if adding additional cartridges causing a jam in the magazine. Haven't been to the range yet to shoot it, but will post results tomorrow.

Looking for a set of diamond checkered grips with screw for a 1958 mfg date S&W model 37 airweight square butt. Call Mark at 727-410-2375