Recent content by nts

  1. N

    Cylinder Release loose, wobble

    I just replaced the latch plunger that goes into the front of the ejector rod on my 629-1. I think the new latch is a MIM part and it fits much tighter into the end of the ejector rod. The MIM part is all polished and smooth where the stock part is roughly ground. It reduced the side to...
  2. N

    S&W fixed my new model 63 :-)

    Here is a story of good customer service. I just bought a new model 63 .22 revolver. I had to special order it since no shop in my area stocked it. If I could have seen it before hand, I'd have never selected it. It had: -defective machining on the ejector star -uneven b/c gap (.008-.014...
  3. N

    S&W fixed my new model 63 :-)

    Here is a story of good customer service. I just bought a new model 63 .22 revolver. I had to special order it since no shop in my area stocked it. If I could have seen it before hand, I'd have never selected it. It had: -defective machining on the ejector star -uneven b/c gap (.008-.014...
See more
Back
Top