Recent content by Ryan4851

I was thinking of using a small piece of gage feeler to slide it in between my front sight and slide. So it will be pushed up and holds the front sight in place. I am thinking of staking the front sight. How it is actually done? I can't find any info on this anywhere. Yeah, $400 for the...

Update: S&W managed to get me the contacts of a local distributor. Thanks to our strict local gun law, the distributor can't give me the front sight unless he pays a permit fee to the government of approx USD400. And our local gun shops don't carry the front sight for me to purchase. So...

Well, I am not located in the states so to call them, I gotta make an international call which cost a bomb here in Singapore. That's why I am sticking to the email. I was thinking if I should just buy the HIVIz Smith and Wesson M&P 9L Front sight to replace my stock sights. Will the M&P 9L...

Update: After 300 rounds, the front sight drifted to the left again. this time, we took out the whole front sight and briefly sand down the old residue and re-apply loctite 620 on it again. I am going to let it cure for atleast 48hrs before I try shooting it again. If all else fails, I am...

My friend at the range used a square punch and hammer to slowly tap the sight back to center. He then use loctite 620 green and let it flow into the gaps. After 24hrs in my case, and after 12o rounds, the front sight seems to hold it place. For now.

I am quite certain it is the problem of your thumb resting on the slide release. I had the same problem in my M&P, until I realised it is because of my thumb position. To verify this, take all your empty mags and load it into the gun and rack the slide back. If it stays back, it most likely...

After 1500 rounds through it, my M&P's front F/O sight drifted very far to the left. So much so that it is about to fall off. I was thinking of using loctite to permanently hold it in place after I re-center it. Should I be using blue or red loctite? Thanks.

Haha yeah. My 2 favourite guns are Shadow and Pro 5".

Thanks for the replies guys. I used my gun mainly for leisure shoot. (I am not doing IPSC or IDPA, atleast not in the near future). So do you guys recommend that I leave my stock trigger alone and let it 'lighten' up with more shooting? Or should I just go get a trigger job.

Hey guys, I bought my M&P Pro 5in from my local gun store (Singapore). I have put about 200 rounds through it. I used a trigger weight gauge to test and it is exactly 6 lbs. The guys at the range told me as I shoot more, the trigger will get lighter. It is supposed to be 4 - 5 1/2 lbs. Will...

My M&P Pro 5in stock. Nothing has been changed yet. Comp-tac desert camo custom holster and mag pouches.