Recent content by Scubapro13

Another good picture. If #1 is not correctly sitting on the magazine which forces the magazine into spot #2 which doesn't allow it to engage the sear #3 Sent from my VS995 using Tapatalk

See pictures Sent from my VS995 using Tapatalk

*questions, *fire. Dann small buttons Sent from my VS995 using Tapatalk

To answer both of them question it will fore a chambered magazine and yes the sear is moving up and down properly. I completely striped the gun yesterday before posting Sent from my VS995 using Tapatalk

Never had any issues probably have 1500 round through it Sent from my VS995 using Tapatalk

I was hoping to be able to fix it but it looks like I may have to send it in. How long does that take it was my edc? Sent from my VS995 using Tapatalk

I wish I would have taken a picture of the new magazine but I'm sure its wearing this corner down? Sent from my VS995 using Tapatalk

If I push down on the magazine as I am putting it in like this it it will work fine but if I stop putting pressure there is nothing Sent from my VS995 using Tapatalk

Nope I figured it was the mag so I just bought a new one and it is still doing the same thing. I can manipulate the magazine when I put it in to engage it Sent from my VS995 using Tapatalk

See picture by thumb Sent from my VS995 using Tapatalk

I may have figured out the issue. The tab that catches the magazine when emptied is not catching completely. I can manipulate the magazine to get the gun to function. But the question is how to fix the problem? Sent from my VS995 using Tapatalk

No contact with trigger pulled Sent from my VS995 using Tapatalk

Correct it absolutely will not fire a chambered round with a magazine in Sent from my VS995 using Tapatalk

First time on this forum. I am having issue with my shield 40. It will not lock back with a empty magazine or fire with a magazine in it. So far I have tried a new magazine and 100 percent taking it apart and cleaning it but still no luck. Any suggestions? Sent from my VS995 using Tapatalk