Recent content by seanct

Do you have any hard data, 50 yards or any distance i guess, for the 9x21 brass? Better/worse/same?

Gun Video Trigger Job: Complete Action Tuning Smith Wesson Revolvers If you have any mechanical ability at all you can follow this video and radically improve a typical sw trigger. There are a lot of nuances that aren't covered but it will get you a long ways...

So, if the gun goes off 100% then there is no effect on accuracy or there is an effect? If the guns is not 100% with your ammo then I would suggest any comments about accuracy are beside the point I think? You are suggesting that if I go to more spring pressure I will have more consistent...

So, the ignition part I get, live that part. Are you saying that even when the primer does pop accuracy suffers from lighter springs? Or are you saying that literally making the spring lighter makes the gun less accurate? This is the part that seems to defy physics. If the springs are...

I am looking for 8 shot subject cylinders for project. I need extractor(s) as well if anyone is selling. Ti preferred but any will do, steel, blued, fluted, unfluted, rust as long as its salvageable... Thanks!

As subject, this is a brand new hogue pau ferro grip for sqaure butt frame. $45 shipped US mail. Paypal money owed/gift preferred but money order is fine as well.

I am looking for a barrel for an N frame/M25, 6" length in 45acp. The factory part number is 045680000 This part is obsolete from S&W. I have called several parts houses that were recommended by S&W customer service and nobody has one. thanks. Parts obtained, thanks!

Sold...I think that was a record... I have 1 set of new unopened XS Sights tritium big dot for M&P to sell. $55, USPS shipping included, payment via paypal or money order. 24/7 Big Dot Sight Set S&W M&P Tritium Thanks, sean

Yeah, I know now. I just got a copy of the S&W shop manual and they show the swaging technique used for that pin. So obvious, but I lacked the experience...

The first time I had moved the pin out for the green loctite and it did hold for about 700 rounds. The second time I repeated that process I managed to get some leakage into the sear(as predicted by tomcat) and the sear locked up. That pin is exceptionally hard and small and I initially tried...

I have a well used 627 that has a problem. The cross pin which holds the double action sear to the hammer is working its way out to the point that it hits the side plate. I assume the pin is held in place by friction against the hammer and the sear moves freely on the pin? It takes several...