Recent content by stackofhay

bumping to the top -

I just found it distracting that the Delta began to disappear as the sights came in line. The sight went back and I am getting another RMR. Sent from my phone.

There are several videos on this subject under Jerry M's YouTube page. He's a real fan of magnaporting his barrel and slide.

I tried the deltapoint "7.5 MOA Delta Dot" configuration on my CORE 9L and when cowitnessed half of the Delta Dot disappeared at the bottom edge of the display. It works fine otherwise but the disappearing dot is a bit disrupting. My other CORE has the 3.5MOA Trijicon RMR and it works perfectly...

Left to right, use a sight pusher otherwise you will have a bear of a time and will mash your punches in the process as you've discovered. Seriously, use penetrating oil and a pusher. Ask me how I know this...

I cannot speak to CA. I did have a gun replaced by another manufacturer though. I had sent my gun in for repair and they elected to replace. They handled the transfer of the SN within the federal system and I was responsible for the state level reporting. I got the impression that because this...

The only component bearing a serial number is the polymer frame. The two steel block assemblies and all other components can be freely replaced. I have heard of a few frames having issues, but mostly, it seems, due to non-factory ammo use.

If you are really serious about wanting to increase the trigger pull of your gun, I have a few MA trigger return springs and sear springs lying around. Send me a PM and I'll mail a set to you. The trigger return spring will increase your pull by 1 to 1.5 LBS and not affect the break of the sear...

Bump - more detail added.

Bump for the weekend

I will swap out a standard striker block, polished and shaped, if you'd rather have that than the FSS striker block that is installed now.

If you have the required tools, it is a very easy job - EXCEPT for removing the rear sight to replace the striker block. This requires a good sight pusher or a lot of courage, a vise, a big hammer and a brass punch you don't mind sacrificing to the cause. The sear is a 15 minute job, max, less...

You can use a ball point pen (tip retracted) as a handy tool to move the little lever. Personally I don't stick my fingers into the action, ever, but I understand the value of physical verification that the gun is EMPTY.

Model 17: Will add 250 rounds of 22lr 40gr LRN ammo for local transfer deals this week only. M&P Range Kit - Price includes shipping, this week only.

bump to the top --------------------------- Edit: I cannot reply to private messages if the senders in box is full. Just sayin' Sent from my GT-P7510 using Tapatalk