Recent content by swabbie

I would like to install a pair of larger target type grips on my DA perfected in order to save the original MOP grips Is this possible and does a vendor here carry them? I know that target 2 screw grips were an option, but they are scarce

further examination reveals that slight rearward prressure on the hammer, will withdraw the firing pin acceptably,and it will not return to the protruding position some kind of transfer bar? gunk in the mechanism? spray clean through the trigger guard or remove the circular side plate/hammer...

I just bought a S&W top break (SN 2695XX) in 38 S&W which I reload and cast for) While examining the pistol, I found that the striker(for lack of a better word) which is a permanent part of the hammer protrudes approx .015-.020 past the flat part of the frame(where the cylinder locks up) The...

resurrecting the thread I was fortunate to obtain a 200 grain .362 diameter 6 cavity Lee mold that had been ordered ,I suspect,from a Cast Boolits group buy I originally bought it to load for my Enfield No2..My first loads were good,no signs of pressure..using Herco..range listed was 3.0 to...

Just picked up a regulation police in 38 S&W.. I noticed that the grip screw is almost rusted in two when I took the weapon apart to clean it.. would also like to know a source for springs and manuals,etc if such a thing exists thanks in advance for any help

Hello... Avid shooter,reloader and bullet caster.. I purchased an Enfield No2, which led to a Regulation police in 38 S&W, which led to a Victory in 38 S&W ,which hasn't arrived yet... I tend to do things by calibers, and the exact same thing happened with 303 Br and 7.62x54... Anyway..I...