Recent content by Tegmi1986

first - 1050$ second - 1150$ the sellers, or rather the heirs, I don't really know what they were selling - brutal but true as life :)

and an interesting fact is that in the German card at their weapons office these revolvers had the production date entered: 1977 and 1978 :)

Thank you for your comments :) The stock in one of them agrees that it is not original because I bought it with a rubber grip installed and this grip is original from the model 27, which the seller sold me without a revolver, but since it was in beautiful condition, I put it on this one 629 :) I...

So I purchased them through the auction portal egun.de from the German market, the German market is very rich in all kinds of weapons, especially short ones used by hunters to finish off game. These revolvers were not really used for hunting, but rather served to potentially put down wounded...

Hello, I will also share with you my two 629 4'' no dash pinned and recessed , that I acquired in the last year from the German market (I am from Poland). Both are in very decent condition after being used by hunters (low shot count), and interestingly they have different fonts for the barrel...

Hello, I will also share with you my two gems that I acquired in the last year from the German market (I am from Poland). Both are in very decent condition after being used by hunters (low shot count), and interestingly they have different fonts for the barrel inscription and different front...

Hello, thank you everyone for your input. Below is the response from the seller for your knowledge: "Hello Tegmi1986, that's correct. I also did some research and saw the same. Yesterday I spoke with the German S&W importer - he also only knows about slotted screws, but couldn't check because...

Hello dear users of this wonderful forum. I'm reaching out to you with a request for opinions. I'm planning to purchase a Smith & Wesson Mod.460 XVR, 8 3/8inch revolver, but I'm concerned about the type of screws used in the side plate. Have any of you ever seen this type of screws in S&W...