Recent content by too tall

Frontline is trying to figure out where they dropped the ball. I'll give them the few days they requested to do so. It was stated if they can't find what happened to the one they think was made and shipped, they would be making me a holster and getting it out quickly thereafter. We shall see.

Well never received the Frontline holster that was ordered back in May. Just sent a message off to them. Anyone else not receive an item from them? Are they still in business?

While the op was about a second gun, it is also the stated use of that gun that these comments are made. It's been stated that no one knows when or how many bad guys there will be. Or words to that effect. For my home and life style I can anticipate what that scenario "might" be. Who, how...

610 Bottom one, a 610-3, brand new.. Have not shot it yet as just got it today. Pumped a box and a half through the 38 above, model 64-6 yesterday though.

Bought two Mecgars for a 6906. I should of sent them back. Had to do a rediculous amount of work to them, break sharp corners a LOT, as in round over the corners, as well as take quite a bit off the weld joint before they would even go in the well, then work them even more to drop out...

I had gotten the Hogue, didn't like it and sent it back. Funny I see the 3 sided rubber for the full size 5900 and not the smaller compact 6900. Have a plate and screws in my shooting wrist from a 2006 auto accident so could use the rubber, the Hogue didn't fit the gun well though.

Searching for rubber to fit my 6906 without finger grooves and doesn't cover the front strap. I see them for the 5900 series but not the shorter mag well 6900 series. Any idea/recommendations? Thanks

Thanks, that helped a lot as the video wasn't that clear on the sear orientation and couldn't zoom in. It's back together now with no worries.

Just watched a video and have the "sear return spring" in the wrong position. It came out during disassembly and I assumed it went down at the bottom of the hammer spring.

Tried it both ways, mostly with it out, then as a last ditch effort with it in. Finally had to just walk away and get educated.

Got the wife's 622 target apart for a deep clean and CANNOT get this side plate back on. Seems the sear won't position to fit into the side plate clearance cutouts. I realize I'm fighting spring side pressure against the pin for the hammer. What am I missing/not seeing?

What did the new springs do for it? Shot my 6906 for the first time recently and it wasn't nearly revolver reliable.

That looks like it may work. Funny their "holster finder" doesn't list it for the 6906. Sure was easier finding good fitting holsters for revolvers.

Fobus is taking their SG-21 back as it didn't fit like their website said it should.

Blackhawk Serpa was out of stock. Kramer was out of my price range at $170. Ordered a Frontline for the model 59. Hopefully it fits the 6906 gun better than the Fobus did. Thanks guys.