Recent content by ULLA!

Sorry for bumping an old thread, but I recently performed this same switch on my 442, which came with a cylinder cut for moon clips. Did you encounter any issues after making the switch? I haven't tested it at the range yet and likely won't unless I get a thumbs up or two.

Thank you so much for the response. Here is a photo of the titanium cylinder with the ratchet from the moon clip cylinder.

I recently performed this switch on my 442, which came with a cylinder cut for moon clips. I used the original ratchet, which is slightly thinner than the ratchet that came with the new cylinder, which was not cut for moon clips. Will this cause any issues? I was hoping to avoid timing issues...