Recent content by Vee Kay

I have a PPK/S that was made way back when, by interarms. How far back does it go? I had an accidental discharge when I moved the safety to the Safe position from fire, while it was cocked. This was back in the 80's, very early 90's...

Thanks! Never saw the detent and the spring. Was too occupied with the buffer retention. Now I just need to find a replacement pin and spring.

Thanks! I changed out the buffer tube, going to an adjustable stock. Thought the buffer tube retainer was the only thing that needed to be held in place with the buffer tube screwed in just far enough. So, what am I watching for with the buffer tube and castle nut?

OK, I'm an AR newbie. After doing some work on my stock, the pin that holds the lower and upper together falls out. Not the pivot pin on the muzzle end, the pin by the buffer tube. What can be done other than putting a piece of duct tape on it to hold it? There's got to be an easy...

I see your thread is about CCI 22. I had federal and Remington ordered through Midway on backorders. Is anyone receiving their orders from last year on anything 22LR? If so, how far out were they? Hopefully Curious!

Well, I've sold my Target stock.... I am the biggest proponent for all citizens to carry, openly and concealed. However the idea of taking a legally carried long gun into businesses is not a well thought out protest. These poor choices are affecting the rest of us in areas where open carry is...

Hope there are a number of 22 LR ammo hoarders and gougers that change their attention to the "Russian calibers". Quite likely 22 LR wil start showing up on shelves that haven't seen them for awhile...

The stainless steel pins I use are magnetic. There are some non-magnetic stainless steel pins available, but the magnetic ones are much easier to work with.