Recent content by VetteBill

  1. V

    SOLD..... ETW Black Leather Holster L-Frame 2-1/2"-3"

    I will take the K frame target grips
  2. V

    469 Magazine

    This is great information. Thanks for the comments
  3. V

    469 Magazine

    I have a 469 aluminum frame that I purchased new well over 30 years ago. Did S&W ever produce a 10 round magazine for this gun?
  4. V

    WTB: S&W 4006 and 469 Magazines

    Still Looking
  5. V

    WTB: S&W 4006 and 469 Magazines

    Let me know what you have
  6. V

    WTB: S&W 4006 and 469 Magazines

    Still Looking
  7. V

    WTB: S&W 4006 and 469 Magazines

    Looking to purchase some 10 round magazines for a S&W 469 9mm and a 4006 40 cal. Please P M with what you have, Thanks
  8. V

    Model 66 Ejector Rod

    Forcing cone looks ok. I believe this one is good to go. Thanks for all the help
  9. V

    Model 66 Ejector Rod

    I removed the side plate and lubed the ejector slide again. I also loosened the ejector rod and re tightened it. The cylinder now open's with out to much effort. Not sure what the problem was but it is working much better now. Thanks for all the help
  10. V

    Model 66 Ejector Rod

    I have lubed and inspected everything. The gun has about 300 rounds through it. It's almost liked the ejector rod plunger is to short
  11. V

    Model 66 Ejector Rod

    The cylinder has been getting difficult to open for a while now. The rear of the cylinder will open some but ejector rod is sticking in the front on the spring loaded plunger. This is a 2.5 inch barrel. Any ideas how to cure this problem would be appreciated.
  12. V

    Model 66 thumb latch issue

    I checked the back of the thumb piece and is not rubbing on the frame. Good advice though
  13. V

    Model 66 thumb latch issue

    When I first tightened the nut the latch would not move. the only way it will slide is if the nut is slightly loose.
  14. V

    Model 66 thumb latch issue

    It has something to do with the new thumb piece I installed
  15. V

    Model 66 thumb latch issue

    After a little time in the range today the cylinder is now hanging up a little when I open it
See more
Back
Top