Quote:
Originally Posted by coastie sai
i hope somebody is still reviewing this thread/forum. . . i'm not always looking around BUT, can someone help me; i want to load copper plated 125 gr .38spl and wanted to use BULLSEYE Powder. I can not find data .. any suggestions?. . . thanks, joe
|
Replied to your PM.
Short version of that is use the mid point data of the FMJ data or data for a cast lead of the same weight.
In the 38 Special when I used Berrys bullets I loaded them almost to FMJ data as they are not going to go over 1200 fps. Don't roll crimp them to hard or you will break through the plating. Crimp a fw dummy rounds and then pull the bullet and you will see and indent. Or as i mentioned buy a taper crimp die.