I recently picked up these revolver grips that are slightly too small for my I-Frame hand ejector.


Does anyone know if they would fit the 32 Top Break DA's, since those used a smaller frame size? Or maybe the M-Frame ladysmiths?



The total length measured top to bottom is 2 1/4", or across from the point of the semicircle to opposite corner is 2 1/2".


Thanks for the advices

First, we don't even know if they are S&W. Second, the only stocks smaller than an I frame were 32 Top-break, 32 Safety revolvers, and 22 Hand Ejector (Ladysmith).

Attached Images

Chart.jpg (57.5 KB, 58 views)

__________________
Gary
SWCA 2515

If you look at the contour of the grips they don’t match that off a Smith & Wesson. They are likely early Iver Johnson’s.
Pearl Grips don’t swap between manufacturers. Sometimes it’s close but no cigar.

Murph