Search results

Hello everyone. I finally got my 432uc to the range yesterday and really had a good range session with it. I had very good, consistent results and I like the gun very much overall. The only thing I need to improve upon is that the gun prints to the left a bit so I need to adjust the sights a...

I recently acquired a S&W model 422 .22LR pistol. Upon pressing the magazine release I have to "pull" the magazines out. It doesn't take much effort but I was wondering if they were supposed to be like that or if they were intended to drop free. Also, does the pistol have a magazine safety? As...

Just wondering if anyone has picked up one of these and has any feedback. Thanks

I have available a grab bag of different accessories. First on the list is five HKS model Mark 3A speedloaders for Colt & Ruger. $5 each I also have one Dade speedloader also marked for Ruger Security Six $5 To add to the speedloader list I have two very odd rubber speedloaders. They seem to...

I have a couple ideas and questions to run by you guys. First off, I am a big guy who is shaped like an apple. When I carry strong side owb even a J frame will sag my pants. I am always hiking up my drawers. This leads me to think both about suspenders and shoulder holsters. I could add a set...

Hello gentlemen, I have been away for a while but I just had to revisit with some questions regarding a newly acquired NY-1 model 64 that I received from J&G. On the crane it is of course marked NY-1, and 64. The curiosity arises in regards to the manufacture date. According to the SCSW it was...

I recently acquired a nice 2" model 12 round butt from a fellow forum member (thanks) and would like to get a set of nice finger groove boot grips for it (wood). I tried a set that I had and was immediately reminded of the model 12's thinner frame. There is space between the grips and the frame...

I have two revolvers that I would like to trade or possibly sell outright. The first is a model 66 no dash 4". It wears pachmayr finger groove grips over a square butt. The gun is one of the early generation 66's with a stainless rear sight. It shoots fine and the timing and lockup are good as...

Hey Guys, I have a model 30-1 that I have never been able to pin down the manufacture date. Serial number is 823XXX. It does not have the flat latch. It does not have the diamond grips, but of course they could have been changed at some time. Finish is nickle and the barrel is 3" From what I...

My apologies to everyone for this being a little off topic. I was not sure where to post this. I was pondering today, and was wondering when certain equipment was developed and became standard for police officers. Mainly I was considering the topic of speed loaders. I know the evolution...