Search results

So after waiting a couple of weeks for the bureaucrats to get my paperwork out to me this week I was finally able to make a little time to slip out and collect the 686 I bought nearly a month ago...well sort of anyway.... :D :D What I had paid for was a 686-3 with a four position adjustable...

I went to a show today looking for a new to me 686. I am after a pre MIM revolver. Found a used but nice no dash M stamped one (AFR prefix). All looked good, just a hint of flame cutting on the top strap, end shake was more than acceptable and timing seemed spot on. Usual nicks and scrapes...

G?Day Again, In my quest for a "new" 686 I am off to look at one over the weekend that is "used" but has literally fired less than 20 rounds. I am however trying to determine (before he and I waste time meeting up as it is an hour drive for each and he really knows nothing about what he has)...

G/Day all, I am presently shopping around for a used 6 inch 686 out here, pre-MIM etc, I have a 4 inch (BDT serial prefix) and looking at that I am still not 100% sure about the front sight blade. My 4 inch and a 6 I am looking at this week both have red ramps, fine on the four but I want a...

....chatting with a mate about .22s this week and he mentioned that one should not be running high velocity .22 in a Model 41 as the factory recoil spring is set up for .22 target ammunition and the HV will batter the pistol as a result. This of course leads me to two questions.... 1. Is there...

Preferably brown leather, plain or basket weave that will hold a HKS 29M (large) loader. Thanks for looking or any directions toward one, new or used. Andy

Steve helped me out with a much sought after Millet sight ... I can't thank him enough for the kindness he showed a virtual stranger..!! Thanks again mate. Andy

...HELP...!! I have been shopping around for a Millett adjustable rear sight to fit a S&W N Frame. Now here is the issue... the N Frame concerned is some what old (1970s) and the front screw hole (small one at the front) was not drilled in a standard location. Millett DID make a rear sight...

G/Day all, I need a few small parts (rear sight spring and lever plate) for my early (1960s with cocked indicator) Mod 41. Other than Numeric are there any suggestions ? Andy