Search results

I'm replacing the front sight on a S&W 910. How do you guys push it into the dovetail w/o mashing the sharp plastic sight edges? Sight is the factory plastic with metal insert in it. I was trying to adjust the original one back to center and I broke it. They don't have a flat spot to push on...

How do you take out the mag release push button ? Stripping frame to refinish it and can't figure out how to take out the button. Thanks, rj

Do grips from a 469 fit on a 908? And as long as I'm asking what other parts interchangability is there as long as staying within same calibers? Any links that would show this? These S&W pistols Gen2,3 seem so similar that it would be nice to know if you could change frame or slides to make...

I have a S&W 10-5 RB and a Tyler T-grip 3 and am wondering the correct way to install it? Do you just take off the stock wood grips and spread the t-grip metal clip over the frame and reinstall wood grips while holding the t grip up in position. It's on the revolver now but has a gap on the...

Just picked up a model 10-5 with serial #c8526xx from a local pawn shop. $270 otd. Looks like it was a safe queen and hardly shot. Anyone know approx dob of it? Thanks, rj

Looking to put a scope /red dot on my pistol and want to know what others have and like. Mainly for target shooting. I have a tack rail to replace the iron sights with. Thanks, rj

I just picked up a 17-2 with the 10 shot aluminum cylinder. $400 OTD. It has holes drilled and tapped under the rear sight that I can see from the cylinder side . What do I need to mount a small scope, red dot sight to it? Does someone make a tact rail specifically for the S&W revolvers? Thanks, rj

I just picked up a very nice model 15-6 ,serial #BHF7585 with 6" barrel and a trigger stop, 3/8" wide hammer and trigger with serrations. Barrel isn't pinned. Adj rear sight with partridge front sight painted red on the sighting edge, 3 screws hold on the side plate. Straight (non-taper)wide...