Search results

Not sure where to put this as there is no training forum, but I bought this fun little laser for my 610 off Amazon. it was $25. It's called the Triton Aimsure and you can have the laser on full time to boresight, or in the dryfire mode, it goes off after you pull the trigger. I just spend 30...

So I have the Brownell Magna tip screwdriver with the 4 bits the two larger ones are marked 210-2 210-4 Both are slightly to wide for the yoke screw. what is the correct size?

New in the box Altamont Round butt K frame Stock. Bought them, tried them on the gun, changed mind. My loss, you gain. $50 shipped. I take PayPal or USPS money order.

This is the screwdriver that came with the model 586 I purchased in 1986. When did S&W stop giving screwdrivers as part of a new pistol? And why? It seems like a nice touch for a pistol your paying close to a grand. Was this a MBA, bean counter cost saving idea? Just curious.

What's the go to mount for newer S&W revolvers that have the threaded three holes on the top strap under the rear sight? Thinking of putting a red dot onto of my 617-6.

I've seen different sizes on the various forums/videos calling out anywhere from a #54 a #55 or a #56 drill bit to drill out the front sight on a S&W. I purchased a new Dawson Fiber optic front sight for my 617 and will be replacing it when it comes back for Smith. Which is the correct bit to use?

So, the burning question, if I ordered a Holster for a K frame Model 66 in 4" barrel, would my 4" K frame model 617 fit? I would think dimensionally, there the same. Frame size, barrel, cylinder diameter (one bored for 38/357, the other for .22 LR

So I take it out and zero. Here is where the rear sight ended up to get it zered at 15 yds. and its bottomed out trying to get a center aim hold. plus the sight blade wiggles back and forth. and look at the cylinder rachets after less than a few hundred rds. Several are chewed up. Do they...

So here is a question. Would a leather Holster that fits a 4" barreled model 586/686 L frame, also fit a K frame model 617 in 22lr? Galco has a holster I like, but only shows it fitting a model 586...

One of the reasons I joined this site was to increase my wheel gun knowledge. I purchased a NIB 4" model 617. When I went to pick it up and do my inspection, this is what I found. Wear on the front and rear sight. finish wear where you can see shiny metal pretty prevalent scoring on the...

Greetings all, new to the Forum, looking forward to getting some great information on my new S7W 617 I just ordered. I've been starting to get the revolver itch. Ironically, my first pistol I ever purchased was a 6" model 586 .357 Magnum way back in 1986. I foolishly sold it a few years...