Search results

39-2 Reply Ps-I can't help but add that your question is not a "dumb" question. It is probably one of the most important questions you could ask. The "dumb" questions are the ones that we are too embaressed, or otherwise reluctant, to ask.

Yes, the 39-2 is very reliable. I have several handguns which cover the spectrum from big to small. Included in the list is one 39-2 and one 639. I don't shoot eather one very much but have put at least a couple thousand rounds through each over the years.I do not recall a single time either one...

Thank You! I did not know the transaction could be made without going through a dealer or other FFL holder if all occurs in same state. Estimator

Thank You! Estimator

When purchasing a firearm from another Forum member does the transaction need to go through a FFL holder?

twin40fives I have 12 mags for my 1076. Do I need that many? Probably not. However,I live in fairbanks Alaska and shoot as much as practible at an outdoor range. My cut-off point is 20 below F. Any colder than that is just too much of a hassle. By having 12 mags I can load them at home and...

I have ordered several mags for my 1076 and am pleased with rapid delivery and the fact they are S&W issue magazines. Not cheap, but if you need them...you need them. Order from: Joe's Pawn Shop Phone: 256-894-9994 Albertville, AL ps; Would never expect to find the mags in a pawn shop but...

I replied on the "Jennings Machine & Tool" website. Thanks, Estimator

I entered information on the "Jennings Machine & Tool " website. Thanks, Estimator

Yes, I took your advice and orderd the LPA sights you mentioned. Thanks, Estimator

Have looked everywhere and cannot find a sight adjustment/removal tool that is either made for, or will fit, S&W model 1076. Any help will be very much appreciated. Thanks to all, Estimator

I reciently purchased a S&W Model 1076 and had primer problems. Two batches of shells were loaded. One with WLP primers and the other with Wolf LP. about every 4th wolf primer failed to fire due to a light firing pin strike. (NOT GOOD!) So, Ordered new spring set and replaced the hammer spring...

Thank You, Estimator

Thank You, Estimator

Thank you! Estimator

Thank you very much for your reply. Estimator

I want to replace the existing hammer spring with a 22 lb spring but am not sure what is involved. I am fairly handy around the reloading bench but am not a gunsmith. The last thing I want to do is cary a shoebox full of parts to a gunsmith and ask him to put my pistol back together. Any advice...

As in most of the country, primers, powder and brass are in short supply here in Alaska, especially primers. Out of desperation, I recently purchased a large amount of Small Pistol Magnum primers at an estate auction. Now I am faced with the challenge of figuring out how to safely use them in my...