Search results

I have a front sight. Both ramp & blade, but it has the red insert. It is factory new and never been installed. I bought it years ago for a model 19. If you are interested, measure up your friends gun and we can see if it is the same size. To install it. the male tung goes into the female slot...

A 5/16 hand reamer will correct the ID of the yoke tube.

Could you send me some pictures, Thanks Bob [email protected]

I may be interested in the cobra, what part of Mi? I'm in Macomb. Thanks Bob [email protected]

Your J frame alignment pin should be .236 and a 15/64 ream should work.

Do you have a E-mail address? Thanks LVBob [email protected]

How long is the screw that you have now? I may have one. Bob

My e-mail is [email protected]

I have a Bo-Mar rib, but it's the target. I think the only difference was the ears on the front sight. I used it for bulleyes target shooting. You have to remove the front and rear sights. Than drill and tap two holes. (I may still have the drill and tap). It will fit a 6 inch K-38 or 19. Bob

After trying what 2006 suggested. Check the hammer block safety and make sure it didn't jump out of place when you reassembled. Next, when you installed the target hammer did you take anything else apart? Is the hammer new or old? Had it been installed on another gun? Did you use the double...

A M-17 cylinder is 1.620. A M-53 cylinder is 1.670.

Could you E-mail me at [email protected] I may have what you need. Thanks Bob

Thanks LVBob

Does any one know of a source that would identifly S & W box's and the years they were used?

E-Mail sent

Those look like my old sap-gloves!