Search results

2 factory 10rd .45acp magazines $45 shipped

I don't believe it's possible to remove it accidentally since removal of the disconnect lever would require replacing the spring that tensions it with a different one. It might be possible that, depending on which APEX kit you purchased, the parts may have been incompatible with a magazine...

Looking to buy a couple of factory 15rd mags for a full size P99 9mm. Not interested in 10rd mags.

I'm no expert on Kimber firearms by any means, but I'm pretty sure you got yourself a frankengun. I believe "Ten II" refers to a series of 1911's Kimber discontinued a while back which had double stacked magazines and polymer frames to accommodate the extra width of the mags. Yours appears to...

With friends like those who needs enemies. J/K but seriously, when that gun was available new, they commonly sold for about 225 nib. The ammo may be worth 100 to 150 depending on brand and type so I would say 300 to 350 MAY be fair

Item is no longer for sale on this forum

Comptac J frame holster is like new (never actuallyworn, just been sitting in a drawer for a while) $50 shipped (cost $78 plus shipping from comptac)

Like new magazines. Selling all 3 for $90 shipped and only paypal is accepted.

per PM, I will take it.

Used very little, looks like new and comes with all of the original adapters. $335 via paypal includes shipping (USA only). PLEASE email me directly if you are interested because I do not receive notifications from this forum. My email address is [email protected]

PLEASE EMAIL ME AT [email protected] IF INTERESTED BECAUSE I DO NOT RECEIVE BOARD NOTIFICATIONS. Excellent condition factory magazine from a S&W M&P 9mm compact. Both base plates are included (flat and finger rest). $50 shipping included. ***Reduced to $40*** ***SPF*** WILL NOT SHIP TO...

Price reduced to $20 shipped.

Will trade for one M&P9c 12rd factory magazine or factory hard case & manual for M&P9c.

This holster has never been worn. Fits M&P9, M&P40, M&P9c, & M&P40c. I believe it will also fit SD9, SD40, & Sigma series as well, but I don't know for 100% certainty. $25 shipped paypal to [email protected]

I finally got around to trying to order mine today and it's no longer showing up on OMB's website. I know it was there last week because I kept checking up on it. The only reason I waited so long is because I wanted to sell my mosquito first. I suspect they probably took it off the site...

I believe the steel cases wear out your extractor and ejector faster. It's not worth it to save 2.5 cents a round. If it were a bigger difference in price then I wouldn't mind using it anyway.

WWB = UMC = Fed Champ = Blazer Brass Personally, I haven't found any major differences. They're all a little dirty, but I have never experienced any reliability issues with any of them. I prefer to shoot Winchester Ranger NATO FMJ though. It's not much more expensive when you order online...

When the white dot from my front sight fell off a while back, I decided to make my own high viz photoluminescent paint. worked fantastic. much brighter than the commercially available stuff and I sold most of what I had left over so it didn't really cost me anything but the time spent on it.

In general terms a "defect in material or craftsmanship" does not refer to something that normally gets worn out over time and/or with use and/or from abuse. The OP stated that the grips "dried out from age." Sounds like normal wear and tear to me.

I did mine that way but after a couple hundred rounds it got hot enough to smear the crayon so I had to remove it.