Search results

Hi, I made some 38 short colt cases from cutdown 38 special cases . Used the Lee seating/crimp die in 9mm . Because of the thicker cut down case size of the 38 special cases, I had to run the finished bullet through the resizer again (no decapper) . Worked for me .

Hi, I must be missing something here ?. Is'nt a 9mm , a rimless case and most revolvers are rimmed cases unless the gun has been adapted for moonclips ? Having said that , I cut down some 38 special cases down to the size of a .38 short colt and then loaded them to .38 super specifications ( I...

PM sent - I will take it

Still looking .

PM sent this afternoon:)

No worries - The missus has upped my budget a little bit so that I am now chasing a used JPoint reflex sight (and hopefully adaptor plate for a N frame revolver) :D Anybody got one no longer required ? Please PM me .

G'Day - SWMBO has given me permission to up my budget so that I can get a decent reflex sight and adaptor plate to suit , if possible . I can't afford a new one but , a good used sight if anyone has one that is no longer required would be great . ;) Budget limit = >$250.00 PM me please if you...

scooter123 -Thanks for that very useful info - Looks like I might have to ask SHMBO if I can save a bit more and go for one of them . (unless I can get an used sight that is in need of re-housing) Anybody got one ?;)

Prefer silver to match stainless gun . Not essential though . Looking in the $100 to $200 price range .

G'Day , I have just started shooting ICORE (limited division) but because of declining eyesight , want to change to ICORE (open division) . I have been looking around for a silver colored red dot reflex sight to mount on my .357 mag. revolver (looks better in my opinion;)) but , have been...

PM sent regarding holster I will definitely take it .:D

No worries - Just made a set of 8 samples . Used 9mm dies to size , seat and crimp , using .356 projectiles . Then used Lee factory carbide die to re-size slightly bulged cases back to .357 . Looks pretty good but am having some sort of problem fitting moon clips into cylinder ( tight fit ) ...

I have a lot of .357 cases that have small splits at the top . I was thinking ,I would trim these cases down to .38 short length (I have way too much time on my hands ;) ). I will then load them with the same data as .38 super (same overall length , powder ,etc ). Cases would ,after loading ,be...

Thanks everyone . I have contacted Steven at Ranch products direct and he is sending me some . No import or export permits are required :)

Hi, Midway only sell to retailers overseas and min.order $500.00 so no good to me . I tried ringing Ranch on the number given to me but only got a recorded message . Also not sure about paying Ranch as , according to their website , they do not accept Visa credit cards and presumably Paypal...

Hi all , I am from Australia . Is there any other contact method other than calling direct ?

Hi Bob, Unfortunately no good for me . I am after some to suit a Model 627 , V-Comp ,.357 , 8 shot ,

Hi All , I have been trying to email the Ranch website at this email address with no reply : [email protected] Anyone know if they have changed their email address ? I am located in Australia and want to order some moon clips , Thanks in advance:)