Search results

Yes, my bad for not doing a better job of inspection before purchase. Just assumed that a factory fresh revolver should be trouble free. I will say that the 610 is billed as a hunting/defense revolver. For me hunting with a revolver involves a slow, deliberate single action pull while sitting in...

Got the word that my new 6.5" 610 had arrived at my dealer. So I get it home and get a better look at things. First thing I notice how heavy the turn line is. A quick inspection of the cylinder stop/bolt reveals a very rough finish to the top radius. The overall finish to the surface of the...

The pic on top right of page 279 in the STD Catalog shows what I think are the sights I'm asking about. Not a very good picture for detail of sight.

Maybe these are the Millet sights used a few years in the late nineties?

Question about seeing a couple model 41s with revolver sights. When were these made and how many were made? I've seen both 5.5 and 7" inch barrels with them.

After doing more online searching using Charles Daly and Kassnar I was able to find some older pics of similar grips. Apparently not made any longer. Thank you again to all who replied and helped identify these grips. Regards, Mike

Right grip label

Bottom grip

Rear view

Right side

I just received a decent model 15, 1971 manufacture in a trade for some old cameras. It is wearing these grips. Nicely fit and finished and I like the color and contour. I believe I have seen similar grips before but cannot find anything searching online. Thanks for any help. Seems I can only...

Dillon 550 dies with conversion kit and tool head. I will take the following per email sent. 38 spl 44 spl/mag 45 Colt

The edge break is not visible without magnification.

To reduce the severity of cylinder turn lines I have for many years polished the contact surface of the cylinder stop. After removing the stop I lightly remove the tool marks from the top surface with a sweeping motion to maintain the radius and keep from introducing flat spots with 600 grit...

I'll take the 25-2

The strain screw was the first thing I checked after the first cylinder. Made sure it hadn't been backed out to light pull. Pretty sure it's the firing pin length. Hope I can get one without sending back to S&W.

Just picked up a 6" 617-4 this past weekend at OGCA here in Ohio. Had time to run a couple cylinders this afternoon. Two cylinders and four FTFs. Very small dimples in rims. Mainspring is full power. Firing pin has very little protrusion above frame. Guessing .020" or less. Will Smith&Wesson...