Search results

I didn't get to really test the accuracy. The range by the cabin didn't have any of the target post left and I left my 10rnd mag at home. I don't think I would go anything over 44.5 with the LC brass. Next time I'm going to also remember my chrono. I'll let you know what I find out.

I ran into the same issue with some of my reloads. I also believe it was due to OCL. I was loading 168 bullets with imr4064 at 44grs. I think it was catching the pmag. It was only happening with one of my 50rnd lots when the mag was completely loaded. I when through 250rnds that day and...

The first thing I notice about this rifle is the action is a little gritty out of the box. I lubed the hell out of it and cycled a bunch of dummy rounds and empty chamber bolt drops. I will admit I did about 500+ before it was nice and loosend up.

Its my understanding they use a different barrel nut. You want the DPMS version. I have that same setup in 15". Really like it. Check this out below. Midwest Industries DPMS 308 Gen-2 SS 12" and 15" Free Float Hand Guards -

The first thing I notice about this rifle is the action is a little gritty out of the box. I lubed the hell out of it and cycled a bunch of dummy rounds and empty chamber bolt drops. I will admit I did about 500+ before it was nice and loosend up.

Same as FL but have a smaller base. Better for auto's.

I had to modify mine to get the troy sling mount to work. Just a little dremel work on the tabs that hang over the lower receiver.

Just order one of those!!! I'll post picks on how it turns out.

I just bought mine and it came with the 20rnd Pmag. I also believe they didn't change anything but the mag.

From the recoil? What did you end up doing?

I think I know why my torque numbers got so high. I was using a Sears beam style wrench and I was not paying attention to how I was holding the handle so it didn't interfere with the output. I just need to get another clicker style wrench.

I just got everything from Midwest. It was really slick because they had the block and dust cover rod on the same page. https://www.midwestindustriesinc.com/index.cfm?fuseaction=category.display&category_ID=253

Just got my M&P10 and put 15 inch hand-guards on last night. Anyone else have a hard time getting the gas tube notch to line up? Meaning if I backed it off to the notch before I was barely at 20 foot-pounds. I had to constantly loosen and torque it again to get it to line up. I was worried...