Looking to do some upgrades to my M&P 10. Any suggestions on a lower vise block that will fit?

This is what I use: AR-STYLE .308 LOWER RECEIVER VISE BLOCK | Brownells

Thanks! I was looking at that one but some reviewer said it was a little too big. Will try it out anyway and sand it down if needed.

This one works great!

Wheeler Engineering Delta Series Lower Receiver Mag Well Vise Block

It and the upper block are a little big but a little strategic sanding and/or trimming does the trick. Keep in mind, they have to make these work with every AR-10/LR308 rifle out there and specs on some may be larger than others. I marked my lower block with a permanent marker after I figured out which end goes into the mag well since the opposite side is for AR-10/M-14 mag wells.

Here's my Home Depot special.... some scraps I had laying around. I couldn't find one quick enough when I wanted to change my handguard on my newly purchased MP10.... It worked as good as my AR 15, AK47 BLOCKS, and cost me about 20 minutes of time...



d

__________________
Jack C