Quote:
Originally Posted by Mack
The 3913 will not work, the design/frames are different. IMO someone is missing the boat by not offering these as an upgrade, are you listening Cylinder and Slide? I have a 908 out of action now because it won't lock a mag in place high enough to disengage the mag disconnect.
m.
|
You can remove the magazine disconnect, if the pistol still feeds from the magazine properly. That might put it back in service.
It's located under the rear sight. I have done it, but it's been a long time since I have done it.
You might ask on the gunsmithing forum, here. My recollection is that it wasn't difficult at all. I just don't want to give you any bad advice.
Somebody there may be to give you better advice than I can.
Good luck.