360J Airweight trigger question - parts

[Dave Baird]

Hey guys, I removed my trigger and a 1/2" long chromed pin fell out. I slid it back in and re-assembled the gun and it seems to work fine. Was there a missing pin or anything that holds that in place? I didn't see any parts lying around and can't seem to find a decent parts diagram.

Thanks,
Dave

 

[BLUEDOT37]

That pin goes inside the rebound slide to act as a trigger stop.

I can live with or without them in.

PS: Are you talking about the trigger lever rod with the rounded end? It just slide in place before you install the trigger. It won't come out once installed.
.

 

[stu1ritter]

Flat end against the rebound slide pin.

Stu

 

[Dave Baird]

Because I couldn't find a parts list, I didn't know what it was called, sorry. Yes, the trigger lever rod came out. I slid it back in, re-installed the trigger and then the rebound spring inside the square block making sure the tiny lip went under the tip of the trigger lever rod. The gun seems to work just fine, I've done this before. I just never had the trigger lever rod come out before. I wasn't sure if it was supposed to be staked inside the trigger or not. I guess it's okay?

Sorry for the dumb question. Even on YouTube, no one mentions it coming out. Dave

 

[stu1ritter]

It's never a dumb question Dave, just something you didn't know.

Stu

 

[Protocall_Design]

On the machined triggers, the trigger lever rod has a pivot pin through it and doesn't fall out. On the MIM triggers, the assembly holds it in place. If you take out the trigger, it falls out.

 

[Dave Baird]

Perfect!!! Thank you all and Merry Christmas!!!!

BE SAFE!!