maxtherabbit
Member
- Joined
- Nov 25, 2011
- Messages
- 36
- Reaction score
- 5
I have everything you need to convert a **wide (.430") hood** 4013 or 4014 to 10mm.
One OEM barrel, professionally chamber reamed to 10mm and recrowned by the forum's own BMCM. It shoots lights out.
Three 4013 magazines converted by me, I did it properly on a manual mill and used OEM 10mm followers - following the procedure outlined in BMCM's thread. Mags are guaranteed to work.
2 Barely used Wolff recoil springs and their associated firing pin springs. 23lbs and 19lbs.
I can't find the thread anymore, but this is a well documented conversion, and with my kit you would have everything you need to shoot 10mm while still retaining the ability to switch safely back to 40s&w with your original unmodified parts. NOTE this is only for SINGLE STACK 4013 or 4014 NON-TSW models.
Asking $350 shipped to the lower 48.
One OEM barrel, professionally chamber reamed to 10mm and recrowned by the forum's own BMCM. It shoots lights out.
Three 4013 magazines converted by me, I did it properly on a manual mill and used OEM 10mm followers - following the procedure outlined in BMCM's thread. Mags are guaranteed to work.
2 Barely used Wolff recoil springs and their associated firing pin springs. 23lbs and 19lbs.
I can't find the thread anymore, but this is a well documented conversion, and with my kit you would have everything you need to shoot 10mm while still retaining the ability to switch safely back to 40s&w with your original unmodified parts. NOTE this is only for SINGLE STACK 4013 or 4014 NON-TSW models.
Asking $350 shipped to the lower 48.
Last edited:
