625JM reduced mainspring and longer FP?

[Rule3]

Yes, now that I think about it (it's been a while) I believe they did say new FP I'll have to dig out the papers. Good idea I can take that one out and measure, If longer I will try it!

Only problem with the links is they are out of stock, neither gives the OAL either??

 

[BlueOvalBandit]

Guess there are exceptions. The stainless strain screws are the worst for loosening. The blued ones stay put better.

The stainless strain screws I seen that have had "thousands through it" without touching the strain screw have usually had the tip so deformed they couldn't turn.

Must be an exception, it's stainless and it does come apart once a year for a cleaning.

The one thing I have trouble with is the ejector rod, go figure.

Only problem with the links is they are out of stock, neither gives the OAL either??

Unless you get some old stock they all should be the 0.495" pins and TomCatt is right to obsess over the "shorties", they are the bane of anyone dropping the trigger pull.