651PD 22 magnum HELP

[Chili501]

I did a trigger job on my 651 and it was working fine until yesterday. The trigger locked back., when I took it back apart the small spring that rotates the cylinder (forgot the name) was loose near the trigger. I found a diagram on the numrich web site but they showed a spring with a hook on the end. The one I have is straight. Based on what I see on the diagram I can't figure out how the spring goes back in. I hope someone can help and maybe have a good diagram.
I did a trigger job on my 686 plus trigger pull in double action is 4.5 lb 3 single. Very smooth.

 

[681ismyfavorite]

I don't condone kitchen table gunsmithing. Send it back to the factory to have it fixed properly.

 

[H Richard]

A 4.5 lb DA trigger is dangerous. That kind of trigger on a rim-fire won't set the primer off. Sounds like you have reinstalled the "Hand" but the spring didn't get set right. There is a tutorial somewhere on the Gunsmithing forum.

 

[Chili501]

That trigger pull is for my 686 Plus.