9mm pocket pistol

franzas

Member
Joined
Jun 29, 2013
Messages
587
Reaction score
333
Location
Richmond, VA
Think about the old .32s- the cylinder was only as long as the round.

Instead of turning a 640 into a 940, what if S&W shortened the J-Frame specifically for the 9mm? It would be way more compact. Nice for pocket carry.

Less jump, too- better for muzzle velocity.
 
Register to hide this ad
I just turned a 60-14 into a 9mm with a cylinder swap. regripped it with an older pachmayer grip and wow is it a comfortable and well balanced revolver.
 
I just turned a 60-14 into a 9mm with a cylinder swap. regripped it with an older pachmayer grip and wow is it a comfortable and well balanced revolver.

Be careful about shooting .355 slugs down a .357 hole. It might not be too terribly accurate, but I'm sure it's fine for SD distances, 5-10 yards. Also, the round won't develop the same velocity in an oversized bore. That could be the difference between an hollowpoint opening up or pissing someone off.
 
Think about the old .32s- the cylinder was only as long as the round.

Instead of turning a 640 into a 940, what if S&W shortened the J-Frame specifically for the 9mm? It would be way more compact. Nice for pocket carry.

Less jump, too- better for muzzle velocity.

Indeed. Especially with the aluminum alloy frame Airweights.

Could lose some serious mass in the cylinder with a 9mm-particular shortened cylinder and frame. Maybe down to 13oz with no fancy materials.
 
Be careful about shooting .355 slugs down a .357 hole. It might not be too terribly accurate, but I'm sure it's fine for SD distances, 5-10 yards. Also, the round won't develop the same velocity in an oversized bore. That could be the difference between an hollowpoint opening up or pissing someone off.

could you handload and expand the case .002 and use the same grain .357 bullets? I'm a complete novice at reloading, that's why I ask.
 
Back
Top