Anyone out there offer a chamber reaming service for a cap and ball six shooter? If have a 1858 Remy (Uberti) .44 and the groove to groove diameter is .453 or so, but my throats Mike at only .448 or so.
I’d like to open up the Chambers to .453 as I plan to use .457 round balls as that should be a good combo for bearing surface.
I know Brownells sells a kit for this but it’s close to $100. I’d rather have a Smith do it to make sure it’s done right.
Thoughts? Thanks!
-Jay
I’d like to open up the Chambers to .453 as I plan to use .457 round balls as that should be a good combo for bearing surface.
I know Brownells sells a kit for this but it’s close to $100. I’d rather have a Smith do it to make sure it’s done right.
Thoughts? Thanks!
-Jay
Last edited:
