Homemade Minnow Bucket
- Thread starter misswired
- Start date
Register to hide this ad
vonn
US Veteran
Wow! That should hold enough minnows.
It certainly makes it lighter to carry your minnows!
#4 shot would have been quicker and funner.
Phil Swift can patch those holes for you.
Ole Joe Clark
Absent Comrade
All the water's gonna run out. 
Have a blessed day,
Leon
Have a blessed day,
Leon
Slow day at home??
But heck you save $6.00
OK for a first attempt, try to get the holes lined up better.
But heck you save $6.00
OK for a first attempt, try to get the holes lined up better.
Last edited:
The only thing better than actual fishing are good fishing videos like this one.
Slow day at home??
But heck you save $6.00
OK for a first attempt, try to get the holes lined up better.
I know you are kidding, but, I spent 1/3 of a forty year career machining tight tolerances inside this place......10 and 12 hour shifts. I could give a rip about hole alignment in a minner' bucket
Beryllium Machining - General Dynamics Mission Systems
I know you are kidding, but, I spent 1/3 of a forty year career machining tight tolerances inside this place......10 and 12 hour shifts. I could give a rip about hole alignment in a minner' bucket
Beryllium Machining - General Dynamics Mission Systems
Dang! GD!! They make the good stuff High Tech for sure. OK we can call it a prototype
for when you make one out exotic materials.
DeathGrip
US Veteran
RG's the man!
Ole Joe Clark
Absent Comrade
I know you are kidding, but, I spent 1/3 of a forty year career machining tight tolerances inside this place......10 and 12 hour shifts. I could give a rip about hole alignment in a minner' bucket
Beryllium Machining - General Dynamics Mission Systems
Beautiful machining, I started out machining back in the day. Actually I started at the deburr table.
I machined a few exotics, some were nasty. Smallest hole I ever drilled was .007 diameter, in brass.
I have a similar bucket, that I rinse my hulls with after washing.
Have a blessed day,
Leon
