Magazine Identification--469/669/6904/6906

[jtduford]

I'm trying to identify this magazine that came with a Model 469 I recently purchased. It fits, but not particularly well, in the 469 (I had to give it a pretty good smack to get it to seat, without which it gets stuck). It did, however, fit and eject just fine in my 6906. I haven't tried to shoot with it, but the follower matches that on my 12-round OEM mags and the dimensions are the same in appearance (except for the bottom plate, which is flat without an extension like the OEM mags). I thought maybe it was for a Marlin Camp, but the peek holes aren't in the right place (from what I've seen) and I have not been able to find any ProMag examples to compare it to. Any thoughts or answers?

 

[tom 45]

it doesn't look like my Pmag but, mine is a 10 round.
If I recall that Pmag was hard to fit in my 469 and didn't feed too well, but fit and fed OK in my 6906 (or vice versa).

 

[tom 45]

Here are a couple of photos of my Pmag.
The base looked like yours before I sanded it down.

 

[VASCAR2]

That base plate is off a 3rd Gen 5904 magazine. Looks like someone replaced the finger extension with the flat base plate. I did that to one of my 6904 mags to aid in concealment.

 

[jtduford]

That base plate is off a 3rd Gen 5904 magazine. Looks like someone replaced the finger extension with the flat base plate. I did that to one of my 6904 mags to aid in concealment.

Yeah, I thought that shape looked very familiar-I have several original 5900 series mags. Thanks!

 

[jtduford]

Here are a couple of photos of my Pmag.
The base looked like yours before I sanded it down.

It does have a strong similar in the positioning of the peek holes. Thanks!