Need to start education on 32 Reg. Police

[pokute]

pokute,

How was the accuracy after you tightened the ejector rod? I assume it went back to normal. Don't worry, you did not mess up the frame. These little guns are tougher than one might think.

I would highly caution against using loctite however. You will want to remove it some day for cleaning. Just remove all oil from the threads on the rod and in the ejector star shaft with alcohol. Then screw it down good and tight with well padded pliers and you should be good to go. Check it occasionally when shooting.

I'm not 100% certain that the pointing did not shift. Unfortunately I noticed the loose rod only after I switched from shooting paper to steel, and was getting tired from putting 300 rounds through my just zeroed K-22. The POA was at least *close* to normal on the 32.

Followup: The pointing shifted because the hold-down screw on the Wondersight was loose!

 

[RalphK22]

Hammer nose on the way from Poppert's. They had no rivets but I think Gun Parts Inc. has them. Any insight on hammer nose install?