No Leading with Laser Cast Bullets?

[Afterguard]

Load them full up. I use 158gn Lasercast over 14.6gns of Alliant 2400 in a 6" 686 and a 16" Rossi M92 with no appreciable leading. Probably about 800 rounds each and just clean both guns normally. They run at almost 1400 fps at this recipe. It's the only bullet i use in the .357s.

 

[Rule3]

I think the OP is still cleaning lead from 2011.

 

[arjay]

Maybe he should just buy a new gun [emoji1]

 

[ironhead7544]

To remove leading, wrap some material from a Chore Boy all copper scouring pad around a bore brush for a really tight fit. Comes out easily.

 

[Nevada Ed]

I had them in my 686 6" in mag cases at a slow 1320 fps target speed.

I did not look for leading.......... I shoot my guns and don't baby them.

Life is to short to look for copper or lead in the bore.........
Just send those bullets down range and reach for more.

 

[Nick B]

For magnum loads why would you want to shoot those ? Jacketed bullets from Zero are cheaper .

 

[Rule3]

Just a FYI this thread is 3 years old.

 

[Nevada Ed]

R3;

you are starting to sound like a guy from PA USA.

Sorry.......... I did not look at post #1
just the current post that had 2014 in it.

Me Bad.