Got my RM06 3.25moa mounted on 4.25" Ported core.
I did swap the lower frame with my other 4.25" because the new ported trigger still has no audible or tacticle reset and I have an apex fss trigger in my old gun.
The ported trigger is pretty good other than the reset though. Long take up but really smooth (no grit) and clean break.
I did a living room zero..to get everthing pretty close at 10yds.
Used a bore sight laser in the barrel pointed at a wall at 10yds,
adjusted the rear irons, then adjusted the RMR dot to superimpose on the laser dot. Also set the streamlight laser to the same. This should put me really close...right?
Will have to get out and shoot to comfirm. Can't wait.
I did swap the lower frame with my other 4.25" because the new ported trigger still has no audible or tacticle reset and I have an apex fss trigger in my old gun.
The ported trigger is pretty good other than the reset though. Long take up but really smooth (no grit) and clean break.
I did a living room zero..to get everthing pretty close at 10yds.
Used a bore sight laser in the barrel pointed at a wall at 10yds,
adjusted the rear irons, then adjusted the RMR dot to superimpose on the laser dot. Also set the streamlight laser to the same. This should put me really close...right?
Will have to get out and shoot to comfirm. Can't wait.
