Should I bend shepherd's crook?

[benhar]

I installed the Apex DCAEK in my new FS 9mm last week. Now when I pull the trigger, the sear does not go flush with the rest of the block. I called Apex about this, and was told as long as the striker is being released this isn't a problem. So, should I leave it be, or open the shepherd's crook a little just to be sure? Is it a risky thing to do? I'm generally against making modifications, but that's at odds with my OCD on this one. I also like the idea of a little less pre-travel.

Side question... does anyone else's trigger bar move to the right side of the frame in addition to moving back? Mine goes to the side while also moving back, but on my Shield it just goes straight back. I'm assuming this may be due to the frame being larger on the FS, but wanted to check.

 

[Bkreutz]

I agree with Apex, if the striker is being released, don't mess with it. None of mine have the sear go completely flat by pulling the trigger.

 

[RobzGuns]

Agreed... As long as the striker is being released, don't mess with it.
Don't be one of those who keep tweaking something until it no longer works.

 

[Rastoff]

Both my 40 and 40c have the sear go completely flush when the trigger is pulled. My 45 does not. I thought it would be a problem. However, after over 2,000 rounds and not a single failure, I'm sure it's OK.

I have not adjusted it and will not adjust it unless it fails. Don't fix it if it ain't broke.

Same with the trigger bar. Don't sweat it until there's a problem.

benhar,
This is not uncommon with those new to a particular pistol. We get them home and in our excitement, we scrutinize every detail. When we find something that doesn't seem perfect, we start wondering. I've run this race many times. It's only after years of shooting that I'm becoming comfortable with little inconsistencies. You will too eventually.

Just go shoot it and report back when it fails. I suspect you won't be reporting back.

 

[benhar]

Thanks all, I'll just leave it be!