Have a very hard to find, very cool S&W revolver for sale. This is an S&W Model 25-2 (.45 ACP) that has been converted by Mag-na-port International to one of their Combat Mini Conversions (2 5/8" barrel) . I bought it a while back and drove to Santa Barbara (twice from Sacramento) to get it (About 800 miles round trip). I've only shot it twice for a total of 100 rounds since I've had it and don't know what the round count was prior to that. But, it's in excellent condition, the timing is perfect, action is velvety smooth, lockup is tight and it shoots great!! Here's the info from the Mag-na-port website on the conversion:
"A custom design for maximum concealability, using a Smith & Wesson 29, 629, 25 or 57 or on any N-Frame revolver. Rework grip frame to round butt k-frame; Mag-Na-Port process; Cut and crown barrel, furnish and remount Baughman front sight; Installation of front locking device; Colored front sight insert, yellow or red; Combat trigger conversion; Semi-bob hammer; Fine tune action."
This gun also has the SS MagNaLife finish that looks similar to brushed stainless steel. It currently has a set of round butt k-frame Pachmayr combat grips on it, but also has a set of fitted finger groove wood grips. The gun is scribed "1-14-86" on the grip frame so I am assuming that's when it was built. I have a 1911 project in the works so the Boss says something has to go to pay for it. Per the website, the cost of the conversion alone, on a customer supplied gun is about $850 and the finish is an additional $295. 1st "I'll take it" followed by a PM or e-mail gets it. Please, no trade offers. Thanks for looking.
$1125/offer
"A custom design for maximum concealability, using a Smith & Wesson 29, 629, 25 or 57 or on any N-Frame revolver. Rework grip frame to round butt k-frame; Mag-Na-Port process; Cut and crown barrel, furnish and remount Baughman front sight; Installation of front locking device; Colored front sight insert, yellow or red; Combat trigger conversion; Semi-bob hammer; Fine tune action."
This gun also has the SS MagNaLife finish that looks similar to brushed stainless steel. It currently has a set of round butt k-frame Pachmayr combat grips on it, but also has a set of fitted finger groove wood grips. The gun is scribed "1-14-86" on the grip frame so I am assuming that's when it was built. I have a 1911 project in the works so the Boss says something has to go to pay for it. Per the website, the cost of the conversion alone, on a customer supplied gun is about $850 and the finish is an additional $295. 1st "I'll take it" followed by a PM or e-mail gets it. Please, no trade offers. Thanks for looking.
$1125/offer
Last edited:
