This may go against the current here, but here goes...

Register to hide this ad
Only time my rifle short stroked was after I got it cerakoted. The guy who did the job didn't remove the bolt and got over spray on it. Ran fine after I cleaned it off. :rolleyes:



The only other time I had a problem was when I had a brain fart and improperly installed the gas tube after installing a low profile gas block. The rifle doesn't cycle if the hole in the tube is faced AWAY from the gas port... :o
 
Think I'm done for now

It's been magpulled quite a bit. My wife says it's done.
 

Attachments

  • 5BFF6BEF-0AC6-4778-B665-A056053E7285.jpg
    5BFF6BEF-0AC6-4778-B665-A056053E7285.jpg
    22.2 KB · Views: 228
Just the complainers post - I've shot hundreds of rounds through mine without issues.

My brand new M&P 10 short strokes, jams, dents the brass, and scrapes the next round. Had to send it back and won't see it for 2+ months. I didn't intend on posting until I saw your comment. ;)
 
Back
Top