(TRADED, please close) - Custom 5" 1911 45ACP w/forged parts

Status
Not open for further replies.
Joined
Nov 9, 2007
Messages
1,008
Reaction score
1,221
Location
Montana & Louisiana
A professionally built, hand fitted 5" 1911 using the following top quality forged parts (no MIM):

Fusion Firearms - forged slide w/serrated top, forged frame w/30lpi frontstrap checkering (covered w/Pachmayr rubber finger grips), match barrel, bushing, hammer

Wilson Combat - sear spring, pin set, ambi-safety, extended slide stop and magazine release, thumb safety

Ed Brown - firing pin, firing pin spring, firing pin stop, recoil spring, grip safety, titanium hammer strut, trigger leaf spring

Nighthawk - Ejector, extractor, sear and disconnect

STI - composite trigger

bright Meprolight Tritium Novak style night sights dated 2012

Smith & Alexander checkered mainspring housing/magwell

VZ Simonich Gunner grips (with the above mentioned Pachmayr finger groove grips)

The finish is matte black Duracoat and the trigger breaks at 4 1/4 lbs with no creep or overtravel. Bore is excellent with sharp lands and grooves.

This 1911 was built as a carry pistol, is very accurate and has approximately 700 flawless rounds through it. It has been carried some, but is in excellent condition with very minor holster wear (see photos). It will ship with one Wilson Combat 8 round magazine in the zippered pistol rug w/side pocket shown in the photo.

You can spend much more for a custom 1911, but it would be difficult to get this quality for any less. Additional photos available via email upon request.

$1595 shipped to your FFL --TRADED--
 

Attachments

  • DSCN5966.jpg
    DSCN5966.jpg
    170.8 KB · Views: 256
  • DSCN5960.jpg
    DSCN5960.jpg
    70.4 KB · Views: 197
  • DSCN5963.jpg
    DSCN5963.jpg
    106.5 KB · Views: 183
  • DSCN5964.jpg
    DSCN5964.jpg
    27.9 KB · Views: 155
  • DSCN5965.jpg
    DSCN5965.jpg
    32.2 KB · Views: 170
Last edited:
Register to hide this ad
Status
Not open for further replies.
Back
Top