- Joined
- Jun 22, 2011
- Messages
- 1
- Reaction score
- 0
Tula ammo
I fired 1000 rds of Tula .45 230gr FMJ through my S&W945 and 2000 rds of Wolf .223 62gr HP through my S&W AR. Here is my observations for both:
The good...
It is THE cheapest ammo on the market.
It is surprisingly accurate.
I can simply throw the cases away because it is not reloadable.
Both loads ran without a single failure through my S&W's after thousands of rounds. Not one hitch.
The bad...
The smoke and powder residue is excessive.
The polymer coating is a bear to clean from the bore! Soak in Hoppe's #9 for 30 minutes, then spin a nylon bore brush on a power drill in the bore until it's clean. Inspect with light and magnifying glass. DO NOT let polymer build up in the bore folks!
It is a weak load, not up to SAAMI pressures, I guarantee it. (That does mean low recoil though!)
NOTE: While my S&W's never had a failure, my Bushy and POF AR's will NOT run Tula or Wolf ammo. I had many FTE's and blown primers...MANY! If I leave a polymer coated round in a hot chamber too long, the coating bakes to the bore and the case will fail to eject. I had to soak the bore with the stuck case overnight in WD40, then tap out the case with a rod the next day. You have been warned!
Will I buy it again? No.
I fired 1000 rds of Tula .45 230gr FMJ through my S&W945 and 2000 rds of Wolf .223 62gr HP through my S&W AR. Here is my observations for both:
The good...
It is THE cheapest ammo on the market.
It is surprisingly accurate.
I can simply throw the cases away because it is not reloadable.
Both loads ran without a single failure through my S&W's after thousands of rounds. Not one hitch.
The bad...
The smoke and powder residue is excessive.
The polymer coating is a bear to clean from the bore! Soak in Hoppe's #9 for 30 minutes, then spin a nylon bore brush on a power drill in the bore until it's clean. Inspect with light and magnifying glass. DO NOT let polymer build up in the bore folks!
It is a weak load, not up to SAAMI pressures, I guarantee it. (That does mean low recoil though!)
NOTE: While my S&W's never had a failure, my Bushy and POF AR's will NOT run Tula or Wolf ammo. I had many FTE's and blown primers...MANY! If I leave a polymer coated round in a hot chamber too long, the coating bakes to the bore and the case will fail to eject. I had to soak the bore with the stuck case overnight in WD40, then tap out the case with a rod the next day. You have been warned!
Will I buy it again? No.