455 Second Crown over 11 on Butt
- Thread starter waltham83
- Start date
Register to hide this ad
PJGP
Member
Picture?!
Peter
Peter
Welcome to the Forum. Markinigs on the British 455s were all over the place. I have an idea that as the production went on and when delivered to England, inspections and stampings became more erratic and sparce over time, with early examples having lots of stamps and later years hardly any. There were about 70,000 2nd Models made and yours serial number suggests it was shipped towards the end of production in 1916. By the time the US became involved with WWI in 1917, England had been at war for nearly 4 years. The 455 revolvers were delivered to England from 1914 to 1917.
Crown over 11 should be a British inspector or view mark as it was called. All three of my 455s had 44 under their crown stamping and were located on the rear left side of the frame, to the rear the hammer.
Is it still in original 455 caliber?
Crown over 11 should be a British inspector or view mark as it was called. All three of my 455s had 44 under their crown stamping and were located on the rear left side of the frame, to the rear the hammer.
Is it still in original 455 caliber?
Last edited:
The Crown with 11 under it on the base of the butt strap is still a Canadian marking, just less common than the crown with 30 under it.
The Savage made Lewis guns in .303 that Canada got in WW1 were stamped with the same crown but the number 24 under it.
So a variety of numerals were used on the S&W .455's. with 30 being the most common.
Regards
AlanD
The Savage made Lewis guns in .303 that Canada got in WW1 were stamped with the same crown but the number 24 under it.
So a variety of numerals were used on the S&W .455's. with 30 being the most common.
Regards
AlanD
PJGP
Member
Surely the number, be it 11 or 30 or whatever, is merely the particular inspector's number?
Peter
Peter
opoefc
US Veteran
Yes, any number seen under a crown is the number of the inspector. Other stampings on a British shipped S&W will tell you if the inspector was at which of the two British inspection locations, London or Birmingham. Ed.
Absalom
SWCA Member, Absent Comrade
Ed:
I believe Birmingham and London were/are the two British proof houses, not military/government inspection stations.
Revolvers received in Britain were usually inspected at RSAF Enfield, a government-run facility outside London. Peter and Alan will know whether there were other sites.
Enfield's inspection military marks actually did not satisfy British civilian requirements, which is why you will often find post-service Birmingham or London commercial proofs on both British and American revolvers that also bear service-applied acceptance marks and the crossed-pennant proof; these couldn't be sold on the commercial market without additional proofing.
acco40
Member
Mine was lettered to the Canadian Government. In addition to the Crown/11 marking on the butt of the revolver, it also has the double broad arrows on the crane.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Last edited:
The opposing arrows were used by Britain and Canada to indicate the gun was sold out of service and was no longer crown property.
So far, I only know of two ways to definitely tell if a 455 is British or Canadian. One is the big "C" and the other is a letter. I would love to see some documentation that ties Inspector "11" and Inspector "30" to Canada only? How do we know that there was no Inspector "11" or "30" in England as well? Does is also mean that all English 455s were only stamped crown over 44?
What were there, 14,500 Canadian 455s ordered directly? Why didn't all of them have the "C" stamp? Also, did they receive any from England and if so were those considered Canadian or British?
So far, I only know of two ways to definitely tell if a 455 is British or Canadian. One is the big "C" and the other is a letter. I would love to see some documentation that ties Inspector "11" and Inspector "30" to Canada only? How do we know that there was no Inspector "11" or "30" in England as well? Does is also mean that all English 455s were only stamped crown over 44?
What were there, 14,500 Canadian 455s ordered directly? Why didn't all of them have the "C" stamp? Also, did they receive any from England and if so were those considered Canadian or British?
Last edited:
Texas Star
US Veteran
Australia certainly got some, and had additional markings for their Military Districts.
Alan David in Sydney may have some and could supply a photo. Hint, hint...
Alan David in Sydney may have some and could supply a photo. Hint, hint...
PJGP
Member
The British contract guns were inspected and proofed by Enfield. The photos (done in a hurry and handheld) show the positioning of the military crossed pennants proof mark and two different inspector's stamps. No similarity with Canadian markings.
Peter
Attachments
I see your example has different inspection markings than mine. All three of miy 455s were stamped as E44, obviously Enfield inspected and I assume that 44 is linked to an individual? Two of mine the opposing arrows, but one has nothing on the front left side of the receiver. I have also seen 455s with maybe only one of the markings and a few with no markings other than NOT ENGLISH MADE on the barrel. It seems that there are no hard fast rules to who did what, but wish that someone had information to validate the non-C marked 455s. Factory letters would be helpful for those E11 guns that link them to Canada shipments.
Attachments
"...with no markings other than NOT ENGLISH MADE on the barrel."
It is hard to read, but the stamp actually says "NOT ENGLISH MAKE".
It is hard to read, but the stamp actually says "NOT ENGLISH MAKE".
I think the 'E' is part of the Enfield Arsenal Inspectors View Mark.
E for Enfield
Crown/#/E
The 'II' stands alone and signifys the Model or 'Mark' of the revolver.
(The # is one assigned to a specific employee/inspector at the Facility.
I'm not aware of any records that'll tie names with the numbers in any era,,but you never know..
So, I would hazzard a guess that a Crown/# would be an English (or Commonwealth?) arms inspector applied mark BUT not done within one of the Royal Arsenal facilitys like Enfield, BSA, LSA, ect.
Maybe one of the Arsenal inspectors assigned right to a factory like S&W, Savage (Lewis Guns).
Or a Canadian small arms inspector doing his/her job and marking the revolvers as they arrive in Canada.
(Seems like the Canadian Ross rifle of WW1 issue was stamped with the Crown/30 (Final?) inspection mark also and was applied at the Quebec Arsenal.
Might be wrong but that's what I seem to recall from my somewhat loose knowledge of the military Ross rifles.)
>
>
That Crown/II mark on the butt of the revolver in the pic posted by acco40
looks more like a view/acceptance mark of the Model (Mark II) than for a an Inspector #2.
Awfully fancy 'II' for a simple inspectors stamp.
(Beautiful Revolver too BTW!)
IIRC the commonly seen '30' on the Canadian MkII's is just a block figure stamp number. No fancy numerals there.
...Those British guys,,,I think they got a new and different set of number and letter stamps every Christmas.
Mine was lettered to the Canadian Government. In addition to the Crown/11 marking on the butt of the revolver, it also has the double broad arrows on the crane.
Sent from my iPhone using Tapatalk
That is a stunning revolver. What was the ship date of this particular gun?
acco40
Member
According the the letter, the revolver was "shipped from our factory on December 4, 1915 and delivered to Canadian Government, Ottawa, Canada.".
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Texas Star
US Veteran
I've seen the theory that the II stamp means chambered for MK II .455 ammo or that it means MK II S&W revolver.
Probably just speculation. And the guns chamber both MK I/.455 Colt ammo and MK II ammo. The MK I gives an additional 150 FPS and is assuredly what I'd try to get, had I lived back then and been using the gun in earnest. The .455 Colt was a commercial loading of MK I, made by Dominion and by Winchester, I think. It was actually slightly more potent than US Govt. loaded .45 Colt, including the M-1909 version with a wider rim.
My S&W .455 had the II stamp. The barrel was marked for caliber. I paid $31.58 for it in Denver about 1965, tax included. The price has risen slightly since then. Nor will you find the ammo on sale at Wal-Mart!
Probably just speculation. And the guns chamber both MK I/.455 Colt ammo and MK II ammo. The MK I gives an additional 150 FPS and is assuredly what I'd try to get, had I lived back then and been using the gun in earnest. The .455 Colt was a commercial loading of MK I, made by Dominion and by Winchester, I think. It was actually slightly more potent than US Govt. loaded .45 Colt, including the M-1909 version with a wider rim.
My S&W .455 had the II stamp. The barrel was marked for caliber. I paid $31.58 for it in Denver about 1965, tax included. The price has risen slightly since then. Nor will you find the ammo on sale at Wal-Mart!
Last edited:
PJGP
Member
No theory, to quote List of Changes 17463 5 Jul 1915: QUOTE The Mark I Smith & Wesson pistol is that described by the Trade as the "Old Model". The Mark II, known as the "New Model", is distinguished by having the numeral II stamped on the left side of the frame. UNQUOTE
The "Old Model" was of course the Triple Lock.
The late Tony Edwards did extensive research into British Military Small Arms Ammo. He gave velocity figures as: Mk I Black Powder 700 fps; Mk I Cordite 600 fps; Mk II (cordite) about 600 fps. The 750 fps Dominion "455 Colt" was I feel sure intended for the RCMP's (stronger?) Colt New Service revolvers.
Peter
Last edited:
Absalom
SWCA Member, Absent Comrade
To my knowledge (which is admittedly limited and which I currently cannot support with sources), the large C-with-broad-arrow was NOT applied as the Canadian military property mark during WW I, but was adopted at some point in the inter-war years.
Any .455's with that mark, most of which based on my spotty observations also have Enfield stampings, should probably be assumed to have entered Canadian service post-WW I by transfer from Britain.
Anyone know more about this? The only thing which would contradict that would be .455's lettered as delivered directly to Canada, stamped with the C. Can anyone show one of those?
